RIP protocol . Over time, routing protocols have evolved to meet the increasing demands of complex networks . The first protocol used was the Routing Information Protocol (RIP). RIP is still popular due to its simplicity and wide compatibility . [1]
Summary
[ hide ]
- 1 What is the RIP protocol?
- 2 Historical influence of RIP
- 3 Evolution of the RIP protocol
- 4 Features
- 5 Propagation of the default route in RIP
- 6 RIP versions
- 7 Advantages of the RIP protocol
- 8 Disadvantages of the RIP protocol
- 9 See Also
- 10 Reference
- 11 Sources
What is the RIP protocol?
The RIP (Routing Information Protocol) protocol is an internal gateway protocol or IGP (Internal Gateway Protocol) used by routers , derived from the XEROX GWINFO protocol and which has become the most compatible protocol for networks Internet, mainly due to its ability to interoperate with any routing equipment, even when it is not considered the most efficient.
Historical influence of RIP
RIP is the oldest distance vector routing protocol . While RIP lacks the sophistication of the most advanced routing protocols, its simplicity and continuous wide use are testament to its persistence . RIP is not a “dying” protocol. In fact, there is now a type of IPv6 RIP called RIPng (next generation).
RIP protocol evolution
RIP evolved from an earlier protocol developed at Xerox , called the Gateway Information Protocol (GWINFO). With the development of the Xerox Network System (XNS), GWINFO evolved to RIP. Later, it became popular as it was implemented in the Berkeley Software Distribution (BSD) as a daemon called routed. The first version of RIP is generally referred to as RIPv1 to distinguish it from RIPv2. However, both versions share many similar functions.
features
- RIP is a distance vector routing protocol .
- RIP uses hop count as its only metric for route selection.
- Posted routes with hop counts greater than 15 are unreachable.
- Messages are transmitted every 30 seconds.
Propagation of the default route in RIP
Every time you add a router to the RIP routing, you would have to configure another static route by default. In various routing protocols, including RIP, you can use the default-information originate command in router configuration mode to specify that this router will originate the default information , when propagating the default static route in RIP updates. [2]
RIP versions
- RIP v1: It does not support subnets or CIDR (Classless Inter-Domain Routing, standard for the interpretation of IP addresses). Nor does it include any message authentication mechanism . Currently in disuse. It is governed by RFC 1058.
- RIP v2: Supports subnets, CIDR and VLSM . It supports authentication using one of the following mechanisms: non-authentication, password authentication, MD5- encoded password authentication (developed by Ronald Rivest). It is governed by RFC 1723-2453.
- RIPng: RIP for IPv6. It is governed by RFC 2080.
Advantages of the RIP protocol
- RIP is easier to configure (compared to other protocols).
- It is an open protocol (it supports derived versions although not necessarily compatible).
- It is supported by most manufacturers.
Disadvantages of the RIP protocol
- Its main disadvantage is that to determine the best metric, it only takes the number of jumps, discarding other criteria (AB, congestion, etc.).
- RIP is also not designed to solve any possible routing problem . RFC 1720 (STD 1) describes these technical limitations of RIP as severe and the IETF is evaluating candidates to replace it in which OSPF is the favorite. This change is hampered by the wide expansion of RIP and the need for adequate agreements [3]




