The fearsome BAD SYSTEM CONFIG INFO error is one of the most common that you can find when starting Windows 10. It appears especially after an operating system update when trying to start the computer.
The terrible thing about this error is that it does not let you enter the Windows system even through the safe mode. For this reason it is more complex than other blue screen errors reported by Microsoft . But fear not, here you will find the solution.
Index( )
- Possible causes of the BAD SYSTEM CONFIG INFO error
- Solutions for possible causes
Possible causes of the BAD SYSTEM CONFIG INFO error
The origin of the problem can vary a lot, but as its name suggests, it is usually associated with elements of the system. The most frequent causes can be from some type of damage to the hard disk as well as to the RAM card itself.
It is also quite possible that it is due to corrupted, deleted system files or their respective registry files. Drivers should also be watched as updating or installing new hardware can cause malfunctions. In sum, the possible causes of this error are:
Device drivers are incorrectly configured , corrupted, or out of date . Controller conflict between a new installed hardware device. RAM damage. It all depends on many factors, both hardware, drivers, firmware or various programs.
Solutions for possible causes
Fortunately, there are several solutions without having to directly format your PC that you can use. Each of them can be carried out by anyone with a minimum of attention and following the instructions properly. Here’s what you can do to fix the BAD SYSTEM CONFIG INFO.
Solution 1: Check and repair disk errors
With this option to check for possible damage to the hard drive you can also repair them. To do this, you just have to follow these steps with CHKDSK.
Click start and type “command” or “cmd” and hit “Enter.” Now type “chkdsk / f” and hit “Enter” again. Follow the commands that you have on the screen until finished.
Solution 2: Hardware compatibility
If you’ve recently connected a hardware device to the computer, unplug it and see if the BAD SYSTEM CONFIG INFO error persists. If so, you have detected a compatibility problem so you must change the device or verify its system.
Solution 3: Update device drivers
Since it is very likely that the failure is due to a driver conflict, it is best to update them directly. Go to “File Management” and right-click on the driver you want to update, selecting “Update Driver.” With this, the specific driver will be updated to its latest version.
Solution 4: Last Known Good Configuration
In the event that it happened to you for the first time, it may be a good idea to return to a previous configuration that does not give you problems.
Open the “Start” window and hold down “Shift” and click “Restart.” This will open a troubleshooting window, in whose advanced options you must select “Startup Settings” and then “Restart”. When you restart the system you will see a black screen with options, and you should “Last known good configuration (Advanced)” and press “Enter”.
Solution 5: Memory Diagnostic Tool
Taking advantage of the very tools that Windows offers to detect and correct its faults, this is an excellent one to isolate the cause of the BAD SYSTEM CONFIG INFO error.
Open “Start,” type “Memory Diagnostic,” and then select “Windows Memory Diagnostic.” To finish, click on “Restart now and analyze for the problem (recommended)”
With this, your PC will restart and try to locate the root of the problem, which will take a few minutes. In case of detecting an error, it is best to contact the manufacturer directly.
Do not forget that the Windows search tool also works to execute commands so if it presents a fault you must attend it with priority.
