If you have a Wi-Fi network and you notice that the signal is very weak in a specific place, you should know that there are dead spots in your network. These are more common than you think and are partly due to different obstructions or not being positioned correctly.
If you have this problem, in this article, see how it is done, we will teach you how to eliminate these annoying dead spots from your Wi-Fi network. In this way, improve connectivity throughout the site.
Index( )
- What are dead spots in a WiFi connection?
- How to know where my WiFi dead spots are?
- How can I get rid of dead spots on a WiFi network?
- Reposition the router
- Update hardware and software
- With a Wi-Fi extender
What are dead spots in a WiFi connection?
Wi-Fi dead spots are those places where the signal is very weak or does not connect properly when a Wi-Fi device or router is nearby.
This is due to several reasons, mainly because the device is not located in the best place . Therefore, it generates some areas where it is difficult to connect.
How to know where my WiFi dead spots are?
If you have noticed that people who are close to Wi-Fi have a better connection than you, it means that there are dead spots on the site. Consequently, something is interfering with your connection.
To know where these Wi-Fi dead spots are, there is a software called Enbex. It establishes an access point connected to a device, such as a laptop with special software.
After this, the site where the signals will be analyzed must be moved through the points, classifying them between weak, strong and critical zones. Afterwards, it will show a heat map which will indicate where the dead spots are.
The green areas mean that there is good connectivity and yellow areas where there is medium connectivity. While the red areas would be for very low connectivity.
In this way you will be able to analyze the dead spots of the place where you are. On the other hand, this software will also be able to automatically calculate the number of access points you need to cover a Wi-Fi installation correctly.
How can I get rid of dead spots on a WiFi network?
If you have already evaluated the speed of your internet and you have problems connecting to the wifi in some places of the site where you are. You may be facing a deadlock problem. This happens for a variety of reasons, so you’ll need to do some observing and research to find out what’s going on.
This is a very common problem and easy to solve, so you should not worry. In general , it is a poor distribution of Wi-Fi in the place where you are, thus creating some deaths. However, with a few simple steps you can improve the connection.
Reposition the router
Although the position of the router may not seem like it, it is usually very important at the time of installing it. There are certain recommendations to take into account because if you have many obstructions your signal will be weaker.
One of them is the floors and walls. If these are far from the device to be connected and you have very solid walls in between, the signal probably arrived weak. In these cases, it is recommended to bring the router device closer to the point where it is necessary , thus avoiding these obstacles that weaken the signal.
Another point to keep in mind is that electronic devices, such as microwaves, telephones, refrigerators, can affect the signal strength. For this reason, it is recommended that there be no such appliances between the equipment and the router.
To avoid this type of difficulty, a position in the house where the router is in a strategic place is recommended. So increase the signal strength , this way we will avoid any dead spots due to the site.
Update hardware and software
Something you should keep in mind is the time you have to use the router. Because if it is a very old model it may not give us the same performance .
Although this is not a frequent problem, it is necessary to check if it is updated with its drivers and firmware respectively . This is recommended so that they can give adequate performance to today’s expectations and requirements.
With a Wi-Fi extender
These devices are ideal for extending and making the Wi-Fi signal stronger at the point where it is needed. The Wi-Fi extender is an intermediary for the Wi-Fi connection, therefore it can avoid thick walls or interference . In this way, it transmits the connection so that the signal arrives stronger.